![]() ![]() I was surprised to see MakeMKV tell me to disable it. I bought the whole SlySoft suite back in 2008. I will often set a 2nd audio track with the AC3 or DTS pass-thru though, but keep in mind it will add size to your files. Set up your Audio how you like it, but unless you are going to be playing back on a home theater system, there is little use for anything but 2-channel. If encode speed is important, though, you may just want to use an RF of 18 instead. I typically run an average bitrate of 2000-2500 for 720p rips and leave the Fast 2-Pass option on. You would really have to stick your nose on your Note 3 to see a difference.įramerate - Same as Source and Constant (some TV/device combinations struggle with variable framerate and 23.97fps) ![]() 99% of the time, you'll be fine with MakeMKV.Īs far as encoding, I agree, you are wasting your time doing 1080p encodes for any mobile device and really for any tablet, either. ![]() Keep in mind they are more complicated and make a difference just a tiny percentage of the time. The ripping tips are good here, although, if you have AnyDVD HD, there are more sure methods. Haven't checked on the quality (had to go to work). Now I'm doing another constant quality encode at RF22 as opposed to the default of 20. There really should be a "Target File Size" setting. How do the pros and pirates do it?īecause I don't know how much audio and subtitle streams will add, I can't easily use the running time to calculate the average video bitrate I need for a 4GB file. ![]() I know 2-pass encodes are supposed to be higher quality with smaller file sizes but Handbrake turns this into a Average Bitrate setting guessing-game. I went back to the source file and reapplied all previous changes between each encode so the effects are cumulative and not multi-generational. I did not use Turbo Pass or specify an average bitrate. Re-encoding to High Profile dropped it to 6.11GB.ĭropping to a Pro Logic II mixdown audio track dropped it to 5.94GB.Ģ-pass encoding dropped it to 884MB and made it crap quality. Well, I took my normal profile 7.86GB Little Shop of Horrors MKV made with Handbrake defaults at Normal profile and tried a few tests: Should I even be using Handbrake? Two-pass encoding? What? I'm sure my files are a lot bigger than they need to be. Long story short: I'd like to know how to get reasonable file sizes for feature-length 1080p movies (preferably under 4GB for FAT32). The current 7GB+ per 1080p movie is not going to cut it: I have a 64GB microSD card and 32GB internal memory and I can fill it all right up with surprisingly few movies or TV shows. In the past I often ripped in HD with huge file sizes and transcoded to SD for phones and such with limited storage, but I recently got a 1080p Galaxy Note 3 and want to carry some 1080p content (especially with my MHL adapter). What I'm usually trying to do is make something suitable for streaming to various media devices and watching in Full HD. What is the fastest way to get the main content off the disc where the bottleneck would be the maximum disc/drive transfer speed and not processing/encoding? I think the best thing would be to get the content off the disc as quickly as possible and then process that rip into a smaller files size. Also, sometimes I forget to check "Large file size" in Handbrake, the result is unplayable, and I end up wasting hours (have to start all over). When a rip can take hours something almost always happens before I can finish, like the drive gets disconnected or tugged or dropped and I have to start the rip all over. OK, my notebook (M11x r3) requires an external optical drive which has been nothing but trouble. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |